Simerom Manual bending device

Simerom  MANUAL BENDING DEVICE
Device for bending of sheet metal, with 90-degree punch, 30-degree punch, and gas punch. Suitable for maintenance and prototype works. Capable of bending bands with a thickness of 3mm and width of 25mm or round steel with a diameter of 6mm and medium strength. Movable stop allows for bend control and repetition. A set of rubber tools is included with the device, and other tools can be delivered upon request.

SHEET METAL CUTTING DEVICE DIT-300 and DIT-600 metal sheet cutting devices, with a maximum bending length of 300mm and 600mm, respectively. Max metal sheet thickness is 2mm, and the maximum needed bending force is 3. The device can cut round drawn steel without losses of material, with a cutting surface that is almost flat due to an accurate guiding of material. The device is manually operated with a hand lever and a system of levers. Range of standard disc diameters.

MANUAL CUTTING DEVICE The device is used for cutting round drawn steel without material loss. It is manually operated with a hand lever and a system of levers. It has a range of standard disc diameters from, and special disks for profiled diameters and cross-sections may be manufactured upon request. It has high endurance for the fixed and movable blades, and there is an option for resharpening. The back gauge length is within 12mm to 150mm, and the dimensions of the base plate are 580mm x 240mm.

MANUAL SHEAR The FGM 110 is a manual shear suitable for cutting sheets up to 1.5mm in thickness. It has a cutting length of 110mm and a weight of 16kg. The device is manually operated with a hand lever and a system of levers. The blades have a high endurance and can be resharpened. The device has a scale and an adjustable back gauge.

MANUAL KNEE PRESSES, The ,5 press is meant for bending, pressing, and punching works. The, 2 press is meant for pressing, punching, and cutting-out leather goods. High reliability is thanks to the rigid welded bed and slide in cylinder hole made up of alloyed steel. It is manually operated by means of a side lever.

The following are the specifications:

PM/MU PM,2 Pressing force on 2 mm from slide travel mm 40 30 Tool holder mini adjusting the slide table on BDC min. mm 10 10 Adjusting the slide table on BDC max. mm 110 110 Table dimensions: Length mm 255 320 and Width mm 110 320. Distance between slide-bed axis mini 70 170 Table moving gauge mm D25 D40 Manual drive force kg max. 25 max. 25 Overall Length mm 330 530 Overall width mm 280 320 Overall height mm 780 625

The press is intended to bend pipes of diameter within 5 and 35 mm, min. curve radius, max. angle 180 degrees.

PIPES BENDING MACHINE Compact built-up, welded enclosure, and detachable leg. The tooling requested for the bending work is as follows: bending segment and support shoe for pipes with a wall thickness of fewer than 2 mm and a support roll for pipes with a wall thickness greater than 2 mm. Bending control is given at the footswitch, with an automatic stop of the bending segment at the imposed angle by a previous adjustment of angle controller.

Max. bend for industrial pipes, hydraulic, health, cooling, microclimate equipment: for steel- max. 35 mm diameter, 2.5 mm wall thickness; for copper and alloyed steel - max. 35 mm diameter, 1.5 mm wall thickness. It is operated by means of a motor-reducer, with overload protection.