Cormak HRBM 50HV Horizontal benders

Cormak HORIZONTAL BENDERS HRBM 50HV HRBM 65HV

Electric bending machines with hydraulic pressure HRBM 50 and 65HV.
This series of machines is equipped with an upper roller clamp hydraulically adjusted. It is an ideal solution for bending rods, pipes, profiles, hollow sections, flat bars, angle bars depending on the bending rollers used into arcs, circles, and spirals. Used for rolling and bending a wide variety of materials depending on the rollers used.
Construction of the bender is made of welded steel sheets.
Hydraulic bender is characterized by higher power in comparison with conventional bending machines.
Both axes of the bender are driven by a strong hydraulic motor, while the upper wheel is lifted by the axis of the hydraulic cylinder.
Panel has buttons for reliable operation of the machine.
Standard bending rolls allow bending different materials in different shapes.
Available equipment:

Set of rollers
Optional equipment page 124

Technical Data
Round pipe [mm]: 70x2 - 100x2
Rectangular pipe [mm]: 70x50x3 - 80x40x3
Circular profile [mm]: 35 - 50
Rectangular profile [mm]: 35x35 - 35x35
Shaft diameter [mm]: 50 - 65
Motor power [kW]: 2.2 - 2.25
Power supply: 3 phases, 400V - 3 phases, 400V
Dimensions [mm]: 1500x950x1340 - 1250x1150x1800
Weight [kg]: 586 - 920

BENDMASTER 40 BENDMASTER 70
This series of machines are characterized by high accuracy and efficiency in bending steel, copper, aluminum, brass pipes. Optimal radius selection allows for high-quality results without material deformation. Presented bending machines are the ideal solution for unit production and small series, for production of details in the car industry, furniture, or in the production of gates, balustrades, etc. The main bender matrix is driven by a high-power reduction gearbox with an electric motor. The device can work in two modes: manual and semi-automatic. The uncomplicated and rugged construction ensures long-lasting, trouble-free use of the machine. The BENDMASTER 40 and BENDMASTER 70 models differ in engine power and bending parameters.

Available equipment:

BENDMASTER 40 machines are equipped with dies for pipes with diameter 16, 20, 25, 32, 40 mm

BENDMASTER 70 machines are equipped with dies for pipes with diameter 40, 50, 70 mm

Optional equipment page 124

Technical Data
Round pipe [mm]: 40x2.5 - 70x3
Square profile [mm]: 40x40x2 - 50x50x2
Max. bending angle: 270° - 270°
Main motor power [kW]: 3 - 5
Dimensions [mm]: 820x550x1030 - 1300x700x900
Weight [kg]: 380 - 680