Ercolina VS 76 megabender

ERCOLINA MEGABENDER V576

Art. 030 INCLUDING: Art. 050A-050B-050D/1-050G-050H-810-FPO10

The main features of this machine:

greater bending capacity;

larger maximum bending radius R380 instead of R300;

Drive system that uses a variable speed inverter;

Machine managed by a new menu system.

Capacity up to depending on material see table.

Minimum bending diameter Ø 5 mm.

Minimum bending radius 2 x Ø varying with wall thickness and material.

Bending radius from R10 to R380.

Maximum bending angle 180.

Variable bending speed automatic or manual using INVERTER system, with acceleration and deceleration for optimum bending.

Microprocessor data management through MENU system that makes it easy to select and use all the machine's functions, including fault self-diagnosis, language selection, and programming.

Bend and spring back angles programmed in 10 program blocks each containing 9 bends, and microprocessor with backup battery for data storage.

Ready to use either with the mandrel bending machine or the two-axis positioning device A40/P for non-mandrel bending.

On request, the Megabender can be factory prepared for fitting with Ring Roller Accessory for bending very large radii. Ring roller Accessory TBCE40MR2 to be ordered separately.

Soft touch keypanel with pre-set functions for mandrel device.

Quick tool changes die and counterbending die in 30 seconds.

Easy to move by its built-in wheels. Rapid counterbending die engage/disengage system.

Dimensions: 680 x 370 x 910 mm.

Weight: 160 lbs body of machine only.

220V SINGLE PHASE POWER SUPPLY.

WITH MINIMUM RADIUS TWICE THE TUBE Ø DEPENDING ON TYPE OF TUBE, Ø WALL THICKNESS.

Art. 030/CE40M2 consisting of: 1 Megabender VS76 Art. 030 with standard accessories 2 drive shafts bending shaft

KIT Version: Art. OK30/CE40M2 consisting of: 1 Megabender VS76 Art. 030 with standard accessories 6 standard formers R46-R56-R67-R90-R100-R150 Art. 151 6 standard counterbending dies Art. 152 1 accessory TB/CE40M2 comprising: 2 drive shafts 1 bending shaft

CAPACITY TABLE:

Ref. Profile Dimensions Ref. Profile Dimensions mm mm

Minimum radii refer to material with tensile strength of 42 kg/mm2 and obtained with one or more rolling runs.

Legend: R5 = standard roll set for tubes and round bars T1 = Tie Bar