Fasti 904 sheet bending machine

Fasti 904 sheet bending machine
The optional combination die (fig. 1- 3) is especially suitable for closing. Here, the material is pre-bent approximately 15 degrees in an initial working cycle. 

Tooling-magazine 
The optional tooling-magazine, which is for location next to the machine, is rail-mounted and can be exactly positioned relative to the bending line. Retraction and withdrawal of tools up to 1000 mm in length is easy. On request, the unit can even be motorized.

We draw your attention to the following: 
1. All deliveries are subject to our General Terms and Conditions of Sales and Delivery.
2. All measures, figures, and weights are without obligation. Alterations in design reserved.
3. When ordering a power-operated machine, please state exact line voltage and frequencies. Otherwise, the machine will be delivered for a line voltage of 230 / 400 V, 50 HZ. Other voltages and frequencies are available against extra charge. In contrast to the standard design, pole-changing motors can only be designed for one nominal voltage. Therefore, clearly state the three-phase mains voltage between two outer conductors (phases), e.g., 230 V or 400V, not 230 / 400 V.
4. Painting is in green acc. to Ø 6011 or grey acc. to Ø 9002, if requested. Special colors against extra charge.
5. All stated sheet thicknesses are based on a yield point of 250 N/mm² or a tensile strength of 400 N/mm², respectively.