Fermat WRF 2g horizontal boring mills

Fermat WRF 2g horizontal boring mills  WRF2G Diameter of Spindle mm Taper of Spindle BIG PLUS option Max. Spindle Speed rpm optionally Main Power CNC SIEMENS S1/56-40 kW Max. Torque SIEMENS CNC S1/56-40 Nm optionally Main Power FANUC S1/S3 kW on request Max. Torque FANUC CNC 51/53 Nm on request X Cross Travel of Column mm Y Vertical Travel of Headstock mm W Spindle Travel mm Z Ram Travel mm Rapid Feed X, Y mm/min Rapid Feed Z, W mm/min Max. Table Load kg Table Size mm A large number of accessories are available. ACCESSORIES DETAILS STANDARD HEADSTOCK The new WRF series - thousands of machining hours experience for your workshop. HIGHER DYNAMICS Rapid travel feed mm/min. Special telescopic way covers for high-speed travels. Linear ways are lubricated with oil. A thin oil layer is cleaning the linear guideways which is a big advantage for machining of castings. SPECIAL DESIGN OF COLUMN 2x ballscrews 100 mm with two absolute scales. Full covers from the front and the back side. Low-profile design - the highest possible Y-Axis travel with the lowest machine total height. TILTING HEADSTOCK ADVANCED TEMPERATURE STABILIZATION X, Y, headstock motors are water-chilled - the heat is dissipated out of the machine to maintain geometry stabilization. Reduction of heat accumulation in the column. Reduction of dust in the column. Better headstock chilling for longer lifetime of bearings. 2 recirculating chilled circuits of the headstock. Chilling of material surrounding the bearings from the outer diameter and prevents the heat from affecting the RAM. Chilling mixture of oil and air which is brought to the main bearings to lubricate them. The mixture is COLUMN then sucked out of the bearings together with the unnecessary heat. Important prolongation of bearings lifetime since the special mixture of oil has a smaller degree of viscosity and thus creates lower temperatures. THE BEST WE CAN BUILD FOR YOU Standard rpm for spindle diameter mm or optionally rpm for spindle dia- meter mm. rpm for spindle diameter mm. Standard kW or optionally kW water-chilled motor from Siemens. Moveable cabin horizontally mm + vertically according to the Y-Travel. 2 independent mechanisms for spindle fall compen- CNC TILTING TABLE sation: Y axis positioning is managed by 2 ball-screws with Heidenhain absolute linear scales. Hydraulic torsion bars are used for ram stiffness stabilization.