Hera sm3 sheet metal working machine

Hera sm3 sheet metal working machine 

Sheet Metal Working Machines and Systems:

- Working width up to 8100 mm
- Pressure force from 800 to 10000 kN
- Heavy all-welded fabrication
- Floor level mounting design to 300 t and 4100 mm working width
- Integrated hydraulic, valve block, proportioning valve control
- Electro-hydraulic synchronization control
- Wide free space, large gap, small table
- Integrated camber facility
- External linear guides
- Flexible tool mounting
- Hydraulic tool clampings
- Motorized stop on up to five axes
- CNC screen control up to eight axes, if required with color/graphic screen
- Low maintenance

Transfer lines for sheets up to 6 mm thickness and up to 2.5 m width have been in operation for 80000 h
- Automatic production plants for series-produced sheet metal parts (shelves, bases, electrical cabinets, doors, radiators, ceiling elements etc.)
- Automatic feed to and discharge from all HERA sheet metal working machines
- Handling and stacking facilities
- Complete design and supply of plants incorporating stored program and CNC controls (hard and software)
- Development of products to suit manufacture

Hydraulic Guillotine Shears:
- Working width up to 6000 mm
- Plate thickness up to 32 mm
- Heavy all-welded fabrication incorporating swing-cut principle
- Integrated hydraulic set, axial piston pump, load-dependent energy consumption
- Central cutting gap adjustment manual or motorized
- Automatically controlled hold-down clamp pressure
- Motorized back gauge with digital display
- Knife change without tension and compression bolts
- Infinitely variable cutting width adjustment
- Electro-hydraulic overload protection
- Special design with motorized front gauge and hydraulic gripping tongs, with stacking facilities, with hold-up device, shearing lines
- Machine control designs: Conventional relays, stored program, CNC and multi-axis screen controls
- Low maintenance

Mechanical Folding Machine:
- Working width up to 6000 mm
- Plate thickness up to 20 mm
- Heavy all-welded fabrication
- All drives on both sides
- Folding beam inside driven by toothed segments
- Front and rear motorized gauge systems
- Wide adjustment range for all beams
- Can always be subsequently equipped with special tools
- Special design
- Double acting folding machines
- Design machine control systems: Conventional relays, stored program, CNC and multi-axis CNC screen controls

Fully Hydraulic Folding Machines:
- Working width up to 6000 mm
- Plate thickness up to 13 mm
- Heavy all-welded fabrication
- Integrated hydraulics proportioning valve control
- Electro-hydraulic synchronization control
- Relatively low, load-dependent energy consumption
- Fast operating speeds, upper beam 100 mm/s, folding beam 60°/s
- Highly accurate positioning, upper beam +/- 0.1 mm, folding beam +/- 0.5°
- Front and rear motorized stop systems
- Special wire design, mesh mat folding machines, transfer lines for plates up to 6 mm
- Multi-axis CNC screen control with DNC interface
- Low maintenance