Hurco autobend p control system

Hurco Autobend Forming/Referencing Increased Productivity With Power Press Brake Gauging Systems From Hurco 1978 Hurco Manufacturing Company, Inc. All rights reserved. Autobend Systems Reduce Setup Time and Material Handling Basic Forming Procedure Example Autobend automatic gauging systems reduce floor-to- The example illustrated here is a panel featuring interlocking joints, reducing floor time to minutes for virtually any part. Formed in three straightforward steps without laying down the part until completion. The material used is 18-gauge steel. Gauging dimensions are inputted quickly using an advanced microprocessor control. Programmable bend allowance, inch/metric units, and a 100-station memory minimize setup and operation time as the system automatically advances to the subsequent gauge dimension for each bend.

The microprocessor control automatically positions the gauges, following the operator's programming. This enables many parts to be formed in one go without having to lay them down, as the gauge aligns automatically for each successive bend during the ram cycles. The outcome is heightened productivity for both short and extended production runs.

Establish the external dimensions of the part to be formed and define the sequence for making the bends.

Input the bend dimensions, forming sequence, and bend order, following the simple reference procedure that establishes an accurate relationship from the punch centerline to the gauge. Subsequently, the digital controller aligns the gauge precisely to the inputted dimensions. if the material allowance into the controller being formed varies in thickness or temper, the gauge Time: to minutes dimensions can be slightly adjusted on the controller until the desired accuracy of the completed part is Form the part complete in one and check achieved. dimensions. Key dimensional corrections into the controller if required. Start forming production parts. Time: to minutes Better Production Program sheets provide planned production, as as a permanent file reference for the exact set-up required With use of s program sheets, repetitive to form jobs can be quickly keyed-in to previously established dimensions, consistent part accuracy and reducing the scrap associated with manual DAT AUTOBEND / PRES BRAKE GAUGING SYSTEM. / PART NO.  REV. OP. NO. PREPARED BY MATERIAL TOOL Thickness x Type ED СD CONTROLLER SETTING Retract Time Material Thickness  Openíng Statíon Dímension Bend AIiowance Retract Front Depth Open Heíght Optional Two-Axis Nsi Punch Díe C1amp Gauge Bar Bars Simplified Referencing Procedure Gauge referencing is not required on any other part formed on the same dies. Whenever the formíng punch and die are changed, they Horízontal and vertícal adjustments for aligning the should be aligned to each other. The Autobend gauge bar is quickly referenced to the punch centerline by following gauge to the formíng tools are supported by hardened and ground rods for greater efficiency and accuracy. these easy steps. Loosen clamps securing gauge bar to the horizontal A pair of hardened and ground reference bars are furnished with a self-centering vee notch accurately supports. located from the ground reference face. Jog ram of press brake down and use power to clamp reference bars at opposite ends between punch and die. When usíng the reference bars, enter into the controller and cause gauge to come ínto positìon. From rear of brake, push gauge bar against reference bars and tighten clamps. Manufacturíng Company. Patents HURGO Box Foreign patents applied for Guion Road lndianapolis, lndiana  HЅF 317 293-5309