Hyllus 290 universal bending machine

Hyllus 290 Universal bending machine, hydraulic control - Item 29010L They present a sturdy construction: these machines are used for different bending jobs both for sharp and round corners: they are conveniently employed for iron furniture, valley forming, containers construction, etc. All the more stressed components are suitably ribbed and reinforced. The shoulders are one-piece cast so that the machine is more steady and accurate. The bed is adjustable vertically by two screws operated contemporaneously by a lateral winch. The movement of the head, that is hold in wide ways, is obtained by a geared motor with safety lamellar joint. The overturning traverse is actuated by two cylinders controlled hydraulically and the bending angle is pre-selected on an adjustable vernier. The further work operations can be done singularly and every operation can be selected previously. Standard equipment: 45 angle blade rear adjustable register spanners grease pump. On request the machine can be equipped with rear adjuster, controlled by handwheel.

Telegraphic code NARVICIOL TITANIOL ERCULES/OL working length mm for plate R=40 Kg/mm2 . mm cap lift. electric motor power HP bed down and overturning table mm approx. weight Kg Reduction unit for motorizing bending machines - Item Nova, Narvic, Titan, Ercules A safety flange coupling permits to adjust the locking pressure of the plate. There is also a stop device with adjustable stop. Special electric motor of remarkable starting torque. Maxi. safety and practicality. Control by pedal push button acting on remote switches. Technical data

electric motor power HP down stroke speed mm/1 or on request mm/1

Reduction unit for motorizing bending machines - Item 291 da mm. 2040 VIS Also in this motorization, the clamping pression is regulated by a safety flange coupling easily adjustable. The finishing accurate 1 degree is a guaranty for a perfect working in the time. Control by pedal push-button acting on remote switches. Technical data

electric motor power HP down stroke speed mm/1 By using this machine it is possible to obtain, very easily, every section. The components made of cast iron are planned so to avoid any flexion. The movement of the cap, that is hold by wide ways, is very light thanks to a double gear reduction: the rotating parts are mounted on ball bearings. The movements of the bed and overturning traverse are very easy and they can be read by two graduated dials. An adjustable counterweight makes very easy and light the bending operation. The device for obtaining little tubes is placed on the same bed of the machine. On request the machine can be equipped with a graduated angular stop. Bending machine equipped with device for tubes Item 291 telegraphic code . VIS standard accessories: 45 blade stick : mm. 18 2 winches working length mm 2040 cylinder : mm. 76 1 lubrication for plate R=40 Kg/mm2 . mm 1.5 pump spanners. cap lift mm 130 bed down and overturning table . mm 100 On request sticks and cylinders of approx. weight . Kg 1450 different diameters are supplied. The structure of this machine is particularly sturdy so to assure an absolute stiffness even under max. work stress. The shoulders are one-piece cast and conveniently ribbed. All the rotating parts are mounted on ball bearings so that the opening and gripping operations are made without excessive efforts. An adjustable balance weight makes very easy and light the bending operation. Bending machine Item 291 standard equipment: 45 blade telegraphic code . VERA mounted on the machine 1 round blade with R 5 mm. 1 working length . mm 1320 rear support set of spanners. for plate R= 40 Kg/mm2 mm 2 cap lift mm 150 On request the machine can be bed down and overturning table . mm 60 equipped with a reducer unit for the 1 approx. weight Kg 850 lifting of the cap.