Okuma LS High speed lathe

Okuma LS Type Productíve Hígh Speed Lathe
Basíc Features
ONE-PIECE CAST BASE CABINET x 4-WAY TOOLPOST 
THREE-BEARING SPINDLE DESIGN x ASA A TYPE SPINDLE NOSE
HARDENED AND GROUND BEDWAYS -x COMPLETE LUBRICATION 
NON-GEOMETRICAL SPEED ARRANGE- SINGLE LEVER INCH-METRIC THREAD
MENT CONVERSION
HIGH EFFICIENCY OF ALL GEARED DRI- x HALF REDUCTION OF LONGITUDINAL
VE TRANSMISSION FEEDS ON CARRIAGE

Standard Accessoríes ínclude :
faceplate 200 mm, 7І,ğ in. 1 set of center knockout bar
center sleeve No. 6 1 set of change gear for DP and module threadíng
centers No. 4 1 set of operating tool in metallíc box
líftíng hooks 1 set of levelíng washers

SPECIFICATION

NOMINAL S1ZE : 450 0г 540 x 800 450 0г 540 x 1,250
swing over bed 450mm oг 540mm 171>i6in. oг 21 in. ι OPTIONAL EQUIPMENTS AND Swing over 6ed at distance of up to
180mm 7 /in. in front of faceplate 500mm oг 580mm 191ήfiin. oг 22 in. ACCESSORiES :
Swing over cross slide 250mm oг 350mm 9 iπ. oг 13з/4in.
Dístance between centers 800mm 31 in. 1,250mm49 in. ι
101ł spindle drive motor and its control
HEADSTOCK:
Hydraulic copying attachment
Number of spindle speeds 12
Tapeг turning attachment Range of spindle speeds 35-1,800 г
7.5kW (101-P) spindIe drive motor and its control
Hydraulic copying attachment
Tapeг turning attachment
CooIant equipment with 0.125 kW motor driven pump
No. 4 Morse taper shank rolling center
400mm (15з/д in.) diameter faceplate
12--130 mm (%-5% in.) diameter steady rest
12-50 mm (%-2 in.) diameter follow rest
Chip guard of transparent plastics material
Quíck-change tool post
% in. diameter foundation bolts with washers and nuts
Wooden chuck stand
Addítional machine base of 100mm (4 in.) іn height
Stop-position safety lock for spíndle control lever
3-jaw scroll chuck
200 mm ( 8 in.) dia.
230 mm ( 9 іn.) dia.
270 mm (10 in.) dia.
310 mm (12 in.) dia.
4-jaw independent chuck
250 mm (10 in.) dia.
300 mm (12 in.) dia.
350 mm (14 in.) dia.
400 mm (16 in.) dia.