Pilous CTR band saw

Pilous CTR band saw

CTR 600 CTR 700 CTR900S CTR 900H JACKO BWIVEL
Swivel 210
Circular blade swivel Saw. Desígned for sawing logs of diameters (up to 1,4 m). It's mobile design enabies the setting-up ríght Ie the heart di the forest where big logs can be converted into number on the spot. Swivel 210 has a single circular blade which saws horízontally on the forward run, is then swung through 90° and saws vertically on the return. As both runs are productíve, sn time is wasted on carriage return or turning the 1og 10 produce square
edged timber (max. 210*210 mm).
The 570 mm diameter tuegstee carbide típped blade produces a smooth finìsh asd the teeth remain sharp for very long periods. To provide qualíty aed relíabílíty, the sawmíll is equípped wíth the 14,9 KW
HONDA petrol engine. Easy to install and operate. supplied with the swível saw ís a blade sharpener.
The blade can be easily sharpened without beìng removed Ttom the machíne.

Electric board thíckness settíng from the operator's control desk. • Very símple manual forward feed.
• In íts category an extraordinarily sturdy desígn of
the whole machíne and a hígh standard of workmanship like with all FORESTOR-PILOUS band saws.
• A high cuttìng performance with minimum cost.
CTB 600 CX
With a HONDA GX 390 K1; 9,6•kW (13 HP) petrol
engine, electronic ignition, hand starter • The engine serves to drive the sawblade • Board thickness setting - manually by a crank • Manual forward feed.
Mobil 600
CTR 600 ard CTR 600 GX Trailer. A uníque and completely new desígn. Transport oе a síngle-axle trailer includíng extending track seetíons. Compared
with a standard mobile band saws Iimíted by the cutting length, this model enables uniiwited cutting lengths dependíng on the number of transported track sections. The trailer conforms to EC regulations, wíth road líghts and brakes. The trailer can also CTR 607 GX
Mobil 600
Be used for transporting the sawn wood.
1) The short length and lightweight design enables the traíler to be towed in ditticult terrain by a small lightweight vehicle.
2) On the site, the base frame and the track sections are installed. The saw unit is lowered to the frame level by two hydraulic cylinders.
3) The saw unit is placed on the track frame.
4) The trailer is removed and the machine is ready to saw.