Rapid ISA lathe tooling

Rapid I.S.A. LATHE TOOL POST RАPID QUICK CHANGE
The Modern Approach to Lathe Operation
14 ECCENTRIC SPANNER
9 SHORT SCREW since 1940
8 HEICHT ADIUSTER
7 BLOCKED SCREW
10 LOND SCREW
TOOL HOLDER 15 LOCATINC PIN CENTRAL BLOCK
Eliminate
ECCENTRIC Increase
Idle time
lathe efficiency
Step up
Guaranted production precіsіon

ADVANTAGES OF THE TOOL POSTS With the RAPID ISA tool post further than carrying the work with the rapidity of a turret lathe, it is possible, thanks to its precision, to carry out in absolute perfection large or small scale production with the suitable number of tools. The necessary tools can be chosen and placed in position with extreme ease and saving of time, thanks to the fast assembly the tool is located directly on to the surface of the tool holder whilst tool height is very confortably adjusted and fixed with the height adjuster and locking screw. The time saving that can be obtained with the RAPID ISA tool post is considerable and becomes more evident in the finishing operation the necessary tools are always assembled and can be changed during the work in three to five seconds. Sharpening of tools can be done many times for every single tool without removing it from the holder.

CONSTRUCTION SPECIFICATIONS
The RAPID ISA TOOL POST is constructed in forged steel, case hardened and with the folllowing parts accurately ground prisms and surface support of the central block, prisms and tools seats in the tool holders, prisms and morsetaper in the morse taper holder, locating pin.
DUE TO OUR LONG EXPERIENCE AND PRODUCTION METHODS AT OUR PLANT WE CAN GUARANTEE YOU PRODUCTS OF EXTREME PRECISION. THE RAPID ISA TOOL POST IS THE ONLY ONE THAT GUARANTEES THE MOST ACCURACY DURING OPERATIONS.

The locating of the toolholder is easy and instantaneous. Even if it badly fitted the precision of its grip is not affected. The height adjusting in relation to the lathe centre is achieved with the use of the height adjuster which is then located in place by a Iocking screw. The simple construction and extreme stability allows very deep cuts, and the use of hard metal tools. Using the tool holder with the vee locator it is possible to fix very solidly round shaped tools. With the morse taper holder it is possible to use drills, reamers etc. Drill feed can be carried out with automatic longitudinal advance without using the tail stock.