Ungerer flat flatness measuring system

Ungerer flat flatness measuring system 

closed-loop control with the Ungerer High Efficiency Roller Leveling Machine, the back-up roll adjustment is set and regulated automatically to achieve optimum flatness and low residual stresses in the strip. The FLAT system is installed close to the leveling machine so that the adjustment will react within a very short response distance. Previously, the process relied on assessing the flatness of the sheets produced, which was only possible after the Levelling Machine, resulting in the need to optimize the settings in a series of steps, and hence the production of expensive scrap. Through the new FLAT system, flatness is automatically measured and regulated effectively. System of feeding. In cases where further processes which could influence the flatness of the strip are to be covered, the system can also be The compact design requires a space of approx. 400 mm only in strip running direction, so that the system is suitable for retrofitting on existing lines. Unflat strip: unevenly spread laser lines. Flat strip: evenly spread laser lines. Product range: Stretch-Bend-Leveling Lines Control system design Planetary gears Development and production of Tension-Leveling Lines Control equipment Crane gears High End Inverter Technology Cut-to-Length Lines Software development Spur gears System solutions for Drives and Rewinding and Inspection Lines Service and maintenance Bevel spur gears Automation Technology Roller Levellers Modification and modernization Change speed gears AC Drive systems with low inertia Edge Trimming and of production lines and machines Special gears Customer oriented design of Cut-to-Length Shears Unflatness Measuring Systems Drive solutions, components, Dimension Measuring Systems systems and lines Surface Inspection Systems Development of Hard- and Software Ungerer Systeme GmbH + Co. KG Prozess- und Automatisierungstechnik Karlsruher Straße 20 D-75179 Flatness Linescanning Automatic Treating UNGERER FLAT Measure Unflatness Achieve Flatness Systeme Prozess- FLAT plane products Field of application: Steel, Stainless steel, Tinplate, Aluminium and other non-ferrous metal strip UNGERER presents FLAT - a completely new measuring system, Width of strip: up to 2400 mm operating without physical contact, for use on Cut-to-Length and Thickness of material: up to 12 mm Leveling Lines. The futuristic system identifies unflatness in the Speed: up to 300 m/min strip material, and this is then presented graphically. Working distance: approx. 700 mm Size in length direction: approx. 400 mm The measured waves and unflatness are evaluated over a measuring distance. The unflatness can then be calculated over each laser line. The result is an unflatness profile over the entire strip width, with significantly greater resolution than the back-up roll pitch of the leveling cassette.