Valdarno VPS 1 Preforming and trimming presses

Valdarno VPS 1 Preforming and trimming presses  The VPS 1/PR-800, with 8000 KN capacity, is utilized for the cold forging of aluminum components. SINGLE PITMAN Two models of this PREFORMING AND trimming presses design are offered. VPS1/PR High energy, long stroke, single pitman with two intermediate shafts and variable speed. VPS1/P High energy, long stroke single pitman. Preforming and trimming tooling Model VPS1/P-1000 with 10000 KN capacity for pre-forming of forged parts. Stroke at rated capacity: mm Bolster table area: mm VP5 1/PR 60 C-FRAME PRESSES Press may be equipped with hydraulic overload device fitted in the ram, controlled by a remote hydraulic system. The RPA 4 160 has a ram with 4 independently adjustable slides. The rigid press frame is weld fabricated and fully stress relieved. This view illustrates the major features of the press. The flywheel runs on bearings housed in the press frame. The pinion gear assembly is immersed in an oil bath. The eccentric shaft is located towards the front of the press for maximum rigidity. Bolster table area: mm