Zdas CXT 120 Pipe bend presses

Zdas Pipe Bend Making Presses
The press for hot forming the pipe bends of blanks prepared in advance. It is designed to press the bends of the following pipes:
Machine desígn
Fastened on the frame of the CXT hydraulic press are three cross beams. Located in the entry and middle cross beams is the drawing bar clamping unit. Located on the exit cross beam are the adjustable back-up pulleys. Between the cross beams, cars move along the rails and displace
the blanks along the drawing bar. The cars are driven by hydraulic cylinders located in the cross beams. To prevent the drawing bars from
deflection when formíng small pipe bends, the press is provided with a supporting table and supporting bar.
The forming is carried out when hot, the blanks are reheated by induction heating. The press is lubricated manually with grease.
Basic technical parameters
cxτ 120
Rated force kN 1 200
Working stroke mm 5 000
Working speed 2
Working speed at max. force 40
Reverse speed 800
Auxiliary car force kN 68
Auxíliary car stroke mm 5 500
Auxiliary car speed 800
Auxiliary car reverse speed 800
Jaw opening mm 160
Clamping force kN 50
Working overpressure MPa 32