Kramer AMS universal bending press

Kramer AMS universal bending press 

A MS,
AML, AMLs,
AMH I-III, AMHs I-III

Universal Bending Press for manual operation

Models: AMS, AML, AMLS, AMH 1-111, AMHs 1-111

All models in the AMS, AML, and AMH series are tailored to specific performance and requirements. They are constructed in stable cast iron. Due to the extensive variety available, it is possible to select an appropriate model for any given working requirement and complement it with many special bars.

Standard Equipment for all Models:
- 45° Triangular bar
- Rounded bar, radius = 3 mm
- Steel bar with fitted clamp-bar for bending check

Special Equipment for AMS:
- Frame
- Counterweight for the bending check
- Width-stop 50-500 mm
- Combined width and finger-stop, adjustable between 10 and 500 mm via cross-beams
- Raised cheeks for top clamping bar span of 200 mm
- Special bars available in many different models

Special Equipment for AML, AMLs:
- Combined width and finger-stop, adjustable between 10 and 500 mm via cross-beams
- Motor drive for top clamping bar and/or bending cheek
- Special bars available in many different models

Special Equipment for AMH 1-111, AMHs 1-111:
- Combined width and finger-stop, adjustable between 10 and 500 mm via cross-beams
- Motor drive for top clamping bar and/or bending cheek
- Special bars available in many different models

For AML 2000: Rounding and bulbing fitting for the building plumber. Bulb-rod Ø 14-30 mm, circular shaft made from unwelded tubular steel Ø 50-120 mm

For AMH 2000: Rounding and bulbing fitting for the building plumber. Bulb-rod Ø 14-30 mm, circular shaft made from unwelded tubular steel Ø 50-120 mm

Technical Data at a Glance:
1. Effective working length (mm)
2. Largest gauge of plate at a tensile strength of 400 N/mm2 (mm)
3. Smallest bending width (Factor X x gauge of plate s) (mm)
4. Smallest internal radius (Factor X x gauge of plate s) (mm)
5. Greatest top clamping bar span (mm)
6. Greatest working setting for the top clamping bar (mm)
7. Lowerability of the bottom cheek and the bending cheek (mm)
8. For progressive rounding up to a radius of (mm)
9. Net weight / seaworthy (kg/kg)
10. Dimensions (mm)
11. Smallest box section (Height x Width)