Retour à l'aperçu

Millutensil MiL263 Die & Mould spotting press Try-out moulds MACH4METAL REIS TUS 7241

Cette machine est vendue

Aller à: Alerte machine

Presse hydraulique Millutensil - MIL 263

MACH-ID 7241

Marque:	Millutensil
Taper:	MIL 263
Contrôle:	Siemens TOUCH 277
Année:	2014

Question WhatsApp

Table load lower table 46.000 Kg
Table load upper table 20.000 Kg
Minimum Die height 300 mm
Maximum Die height 2400 mm

Equipped with options
Tilting table 180 Gr
Electric paralel control system
X-travel lower base extensions to 2000 mm

Caractéristiques

Métrique US Standard

Passage entre montants 2130 x 2730 mm 2130 x 2730 inch

Profondeur du col de signe 2400 mm 94.488 inch

Table Length 2500 x 2000 mm 2500 x 2000 inch

Ram stroke 2100 mm 82.677 inch

Approche speed 80 mm/min. 80 mm/min.

Vitesse 8 mm/min. 8 mm/min.

Return speed 50 mm/min. 50 mm/min.

Table rotation 180 U/mm 180 U/mm

Dimensions (Estimation)

Longueur 7800 mm 307.086 inch

Largeur 5600 mm 220.472 inch

Hauteur 6510 mm 256.299 inch

Poids 56000 kg 123514.7 lbs

Important : les informations sur cette page ont été obtenues au meilleur de nos connaissances auprès des fabricants. L'exactitude n'est pas garantie mais les informations sont données de bonne foi. En conséquence, cela ne constitue pas une représentation ou des conditions contractuelles. Nous vous recommandons de vérifier tous les détails essentiels !

Partager sur

Téléchargements

Téléchargez toutes les photos Brochure

Millutensil ML Brochure Blue line.pdf

Partager sur

The MiL 263 spotting presses for assembly, adjustment, check and reapir for large moulds.

This press is used for splitting, adjusting, maintenance and try-out operations

on dies and moulds (thermoplastics, die casting, thermosetting, rubber and blanking)

The lower table is build in floor pit version

The die & mould spotting presses of the traditional MIL series feature the extensible plate exit on the side, towards the short side of the distance between columns. They are typically used in the plastics, rubber and die casting sectors.
This solution allows tilting on the extensible plate short side up to 70° on both sides. In this version, the upper plate, too, is tilted on the short side from 100° to 180°.

The MIL series provides great advantages compared to other solutions with long side rotation

Better working ergonomics, granting the operator to have easy access to any mould part without the use of platforms;
Much shorter total press height above ground, which often reduces excess costs for foundations;
Wide base press structure with greater stability;
The two mould-halves are located on the same side, so operators have an overview of the whole mould and can work more comfortably