Гідравлічний прес Millutensil - MIL263

The MiL 263 spotting presses for assembly, adjustment, check and reapir for large moulds.

This press is used for splitting, adjusting, maintenance and try-out operations

on dies and moulds (thermoplastics, die casting, thermosetting, rubber and blanking)

The lower table is build in floor pit version

The die & mould spotting presses of the traditional MIL series feature the extensible plate exit on the side, towards the short side of the distance between columns. They are typically used in the plastics, rubber and die casting sectors.
This solution allows tilting on the extensible plate short side up to 70° on both sides. In this version, the upper plate, too, is tilted on the short side from 100° to 180°.

The MIL series provides great advantages compared to other solutions with long side rotation

• Better working ergonomics, granting the operator to have easy access to any mould part without the use of platforms;
• Much shorter total press height above ground, which often reduces excess costs for foundations;
• Wide base press structure with greater stability;
• The two mould-halves are located on the same side, so operators have an overview of the whole mould and can work more comfortably